part no. ecn # rev -a revisions description drawn date date date checkd apprvd 07/2/11 shashi 07/2/11 21/2/11 jagan farnell released mcSC5018-2R7MU this data sheet and its contents (the "information") belong to the premier farnell group (the "group") or are licensed to it. no licence is granted for the use of it other than for information purposes in connection with the products to which it relates. no licence of any intellectual property rights is granted. the information is subject to change with- out notice and replaces all data sheets previously supplied. the information supplied is believed to be accurate but the group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. users of this data sheet should check for themselves the information and the suitability of the prod- ucts for their purpose and not make any assumptions based on information included or omitted. liability for loss or damage resulting from any reliance on the information or use of it (including liability resulting from negligence or where the group was aware of the possibility of such loss or damage arising) is excluded. this will not operate to limit or restrict the group's liability for death or personal injury resulting from its negligence. spc multicomp is the registered trademark of the group. ? premier farnell plc 2011. tolerances: drawn by: shashi jagan farnell checked by: approved by: date: drawing title: inductor SC5018-2R7MU m10002651 07/02/11 date: size scale: nts u.o.m.: mm sheet: 1 of 3 dwg no. electronic file rev a 07/02/11 a date: 21/02/11 unless otherwise specified, dimensions are for reference purposes only. configurations and dimensions a 12.6 0.4 mm - b 12.6 0.4 mm - c 4.6 0.4 mm - d 12.7 0.4 mm - e 7.6 0.4 mm - f 2.4 mm (reference) g 5 0.4 mm - 300khz 0.25v l 2.7 h 20% ta = 25c dcr 4.3m ? 7% 300khz 0.25v i rms = 15a (maximum) l at i rms 2.22 h (reference) 300khz 0.25v i max = 24a (maximum) l at i max 1.93 h (reference) dimensions : millimetres electrical characteristics operating temperature: -40c to +150c note i rms : dc current rating at 50c temperature raise (typical ) i max : dc current rating at 100c temperature raise (typical) marking : 2r7 1. the long pin is the beginning of winding. yyww schematic diagram note: 1. wire fw031240054505t5-a28 2. 5.5ts test item a mm b mm c mm d mm e mm f mm g mm specification 12.6 0.4 12.6 0.4 4.6 0.4 12.7 0.4 7.6 0.4 2.4 (reference) 5 0.4 1 12.75 12.76 4.76 12.77 7.75 2.38 4.74 2 12.76 12.77 4.82 12.8 7.69 2.39 4.79 3 12.73 12.74 4.79 12.83 7.78 2.38 4.84 4 12.76 12.76 4.71 12.87 7.69 4.88 5 12.74 12.75 4.73 12.76 7.75 2.39 4.86 average 12.75 12.76 4.76 12.81 7.73 2.38 4.82 test data for mechanical free datasheet http://www.datasheet-pdf.com/
part no. ecn # rev -a revisions description drawn date date date checkd apprvd 07/2/11 shashi 07/2/11 21/2/11 jagan farnell released mcSC5018-2R7MU this data sheet and its contents (the "information") belong to the premier farnell group (the "group") or are licensed to it. no licence is granted for the use of it other than for information purposes in connection with the products to which it relates. no licence of any intellectual property rights is granted. the information is subject to change with- out notice and replaces all data sheets previously supplied. the information supplied is believed to be accurate but the group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. users of this data sheet should check for themselves the information and the suitability of the prod- ucts for their purpose and not make any assumptions based on information included or omitted. liability for loss or damage resulting from any reliance on the information or use of it (including liability resulting from negligence or where the group was aware of the possibility of such loss or damage arising) is excluded. this will not operate to limit or restrict the group's liability for death or personal injury resulting from its negligence. spc multicomp is the registered trademark of the group. ? premier farnell plc 2011. tolerances: drawn by: shashi jagan farnell checked by: approved by: date: drawing title: inductor SC5018-2R7MU m10002651 07/02/11 date: size scale: nts u.o.m.: mm sheet: 2 of 3 dwg no. electronic file rev a 07/02/11 a date: 21/02/11 unless otherwise specified, dimensions are for reference purposes only. test item l h dcr m ? ? l at i rms h l at i max h condition 300khz 0.25v at 25c 300khz 0.25v i rms = 15a (maximum) 300khz 0.25v i max = 24a (maximum) specification 2.7 20% 4.3 7% 2.22 (reference) 1.93 (reference) 1 2.58 4.19 2.14 1.9 2 2.68 2.21 1.97 3 2.66 2.18 1.93 4 2.65 2.16 1.92 5 2.67 4.2 2.18 1.93 average 2.65 4.19 2.17 1.93 test data for electrical electric characteristics free datasheet http://www.datasheet-pdf.com/
|
